Lantronix EDS1100 Betriebsanweisung PDF herunterladen (Seite 45)

8: Line and Tunnel Settings

EDS1100/2100 User Guide 44

3. Click Submit.

Line Command Mode

To configure the Command Mode, perform the following steps.

1. Click Line > Line 1 > Command Mode. Figure 8-4 shows the page that displays.

Flow Control Select the flow control from the drop-down menu. The default is None.

Xon Char Specify the character to use to start the flow of data when Flow Control is set

to Software. Prefix a decimal character with \ or a hexadecimal character with

0x, or provide a single printable character. The default Xon char is 0x11.

Xoff Char Specify the character to use to stop the flow of data when Flow Control is set

to Software. Prefix a decimal character with \ or a hexadecimal character with

0x, or provide a single printable character. The default Xoff char is 0x13.

Gap Timer The driver forwards received serial bytes after the Gap Timer delay from the

last character received. By default, the delay is four character periods at the

current baud rate (minimum 1 ms).

Threshold The driver will also forward received characters after Threshold bytes have

been received.

Table 8-3 Line 1 Configuration Fields (continued)

Field Description

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 156 157

Keine Kommentare

Lantronix EDS1100 Betriebsanweisung Seite 45