Lantronix SCS1620 Betriebsanweisung PDF herunterladen (Seite 99)

SCSxx05/SCSxx20 User Guide 8: Commands

8-12

User Commands

After the user logs in to the system, the user name becomes the command

prompt. For example, ross> displays after Ross logs in.

Users log in to identify themselves to the system and to access the device ports

to which the system administrator has assigned them privileges.

select

Use select <port name or number> to select a port (only applies to ports for

which this user is allowed clear, direct, or listen access).

direct

Use direct <port name or number> to connect to a port (only applies to a port

for which this user is allowed direct access).

telnetconfig

Use telnetconfig < port name or number> or telnetconfig <IP address> to

assign a unique TCP port or IP address to a device port so that Telnet can be

used to connect to the device port. Only the sysadmin user has permission to run

telnetconfig. Users who wish to Telnet to a device port must have must have

direct access rights to use this command.

listen

Use listen <port name or number> to listen to a port (only applies to ports for

which this user is allowed listen access).

clear

Use clear <port name or number> to clear the buffer of a device port (only

applies to ports for which this user is allowed clear access).

exit

Use exit to disconnect from a port that you are connected to. When you are

disconnected, the command line displays.

logout

The user can log out of a port connection by typing logout on the command line.

Break Sequence

The user can send a break signal to the external device using a programmed

break sequence. The preset value for this option is Esc+B (performed quickly but

not simultaneously).

Escape Sequence

The user can disconnect from a port by using a programmed escape sequence.

The preset value for this option is Esc+A (performed quickly but not

simultaneously).

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 140 141

Keine Kommentare

Lantronix SCS1620 Betriebsanweisung Seite 99